Data still to be completed------(<---links)
	PRODUCT DATA of Stycast 1090

Material	Stycast 1090
Product Datasheet	stycast1090
General Information	STYCAST 1090 is a low density, syntactic foam epoxy encapsulant
Product Type	Syntactic casting, potting, foam, 2-part.
Chemical Composition	Epoxy
Name of Manufacturer	Emerson & Cumming Nijerheidsstraat 7, B-2260 Westerlo, Belgium +32 14 56 25 00 +32 14 56 25 01 www.emersoncuming.com

	EXPERIENCE IN PRACTICE

Development Status	Commercial Product
Cost Range	Medium
Lot Reproducibility	Excellent
Space Experience	Excellent

	PHYSICAL PROPERTIES

Specific Gravity	0.88 Data Quality: Manufacturer's data
Viscosity	30000 cP Remark: (before reaction) Manufacturer’s Data
Pot Life	30 min Data Quality: Manufacturer's data

	ELECTRICAL PROPERTIES

Electrical Volume Resistivity	1e10 ohm.m Data Quality: Manufacturer's data
Loss Factor	0.02 @ 60 Hz.
Dielectric Constant	3.9 @ 60 Hz.
Dielectric Strength	14.8 Data Quality: Manufacturer's data

	THERMAL PROPERTIES

Thermal Conductivity	0.167 W/m.K Data Quality: Manufacturer's data
Thermal Expansion Coefficient	40 μstrain/°C Data Quality: Manufacturer's data

	RELEVANT PROPERTIES FOR USE IN SPACE COMMUNITY

Flammability	Pass (23.8% O2) Test: NASA NHB 8060-1B
Toxicity/Offgassing	Pass Test: NASA NHB 8060-1A
Temperature Range(space)	-75°C to +200°C. Test: Manufacturer’s Data
Outgassing	TML = 0.75%, RML =0.35%, CVCM = 0.06% Test: ECSS-Q-70-02
Water Absorption	0.004 Test: 24 hours @ 25°C

	SPECIAL RECOMMENDATIONS

Special Recommendations

This product is filled with micro-balloons which must be thoroughly dispersed at the time of use. · The resin must be deaerated (by vacuum exposure) before casting and also briefly after casting. · Recommended cure is 24 hours at room temperature. Post cure at 60°C may be applied to reduce outgassing. · Post cure at 60°C for 24 hours is compulsory when material is used as insert potting. · Temperature range and cure schedule are dependent on the catalyst used. Both 9 and 11 have space approval, and experience in space use. · Different catalysts will also affect other properties.