All data is for information only------(<---links)
	PRODUCT DATA of Dunmore TM05564

Material	Dunmore TM05564
Product Type	Thermal Control Plastic Film
Chemical Composition	Fluorocarbon (FEP-Type C), Aluminised
Name of Manufacturer	Dunmore Coorperation Keystone Industrial Park, 2900 Wharton Rd., Bristol, PA 19007, USA +1 215 781 8895 +1 215 781 9293 www.dunmore.com

	EXPERIENCE IN PRACTICE

Development Status	Special Commercial Product
Cost Range	High
Lot Reproducibility	Good
Space Experience	Limited

	PHYSICAL PROPERTIES

Specific Gravity	2.15 Data Quality: Manufacturer's data
Standard Width	122 mm Data Quality: Manufacturer's data
Thickness	0.05 mm Data Quality: Manufacturer's data

	ELECTRICAL PROPERTIES

Electrical surface resistance	1e15 ohm(minimum) Remark: Dupont Data/ASTM D257-61
Electrical Volume Resistivity	1e15 ohm.m(minimum) Remark: Dupont Data
Dielectric Strength	160 kV/mm @ 23°C on FEP Film) Remark: Dupont Data

	THERMAL PROPERTIES

Thermal Conductivity	0.194 W/m.K Remark:Dupont Data
Thermal Expansion Coefficient	89.3 μstrain/°C Remark:Dupont Data (-50 to +70°C)
Specific Heat	1.17 J/g.K Remark:Dupont Data (-50 to +70°C)

	RELEVANT PROPERTIES FOR USE IN SPACE COMMUNITY

Temperature Range(space)	-175 to +150°C. Max. Operating Temp. 205°C Test:Dupont Data
Outgassing	TML = 0.21%, CVCM = 0.00% Test:ASTM E-595
Moisture Absorption	1.3% @ 50% RH Test:Dupont Data (@ 23°C)

	SPECIAL RECOMMENDATIONS

Special Recommendations

Normal use is for external sheet on multilayer insulation (MLI). Suitable venting is recommended · This product is also available in 8, 12, 75 and 125 micron thicknesses. · Available in a range of widths, depending on film thickness. · Also available in two(2)-side-treated form for VDAL bonding, designated as Type C-20; to be specified at time of purchase. · The full Dunmore part number must be designated for precise material description. · Perforated versions of the above-mentioned films are available. Patterns are to be specified at the time of ordering.