| All data is for information only------(Home) | |
|---|---|
| PRODUCT DATA of DC 93500 |
| Material | DC 93500 |
| Safety Datasheet | DC93500 msds |
| Product Datasheet | DC 93500 |
| Product Type | Two-part adhesive, potting, coating |
| Chemical Composition | Silicone |
| Name of Manufacturer | Dow Corning N.V.
Parc Industriel, Zone C, B-7180 Senette, Belgium +32-64-88 80 00 +32-64-88 84 01 www.dowcorning.com |
| EXPERIENCE IN PRACTICE |
|---|
| Development Status | Special Commercial Product |
| Cost Range | Very High |
| Lot Reproducibility | Good |
| Equivalent Designations | DC 93-500 |
| Space Experience | Extensive |
| PHYSICAL PROPERTIES |
|---|
| Specific Gravity | 1.08 @ 25°C |
| Viscosity | 8400 cP @ 25°C |
| Pot Life | 120 min @ 25°C |
| Shelf Life | 24 month Data Quality: Manufacturer's data |
| ELECTRICAL PROPERTIES |
|---|
| Electrical Volume Resistivity | 6.9e12 ohm.m Remark:ASTM D257 |
| Loss Factor | 0.0011 Remark: ASTM D150 (100 Hz) |
| Dielectric Constant | 2.75 Remark: ASTM D150 (100 Hz) |
| Dielectric Strength | 14.8 kV/mm Remark: ASTM D149 |
| THERMAL PROPERTIES |
|---|
| Thermal Conductivity | 0.146 W/m.K Data Quality: Manufacturer's data |
| Thermal Expansion Coefficient | 300 μstrain/°C Data Quality: Manufacturer's data |
| Specific Heat | 0.867 J/g.K @ 0°C |
| Glass Transition Temperature | -84 °C
Remark: TMA |
| RELEVANT PROPERTIES FOR USE IN SPACE COMMUNITY |
|---|
| Flammability | Pass (24.5% O2): tested as coating on FR4 PCB Test:NASA NHB 8060-1B |
| Thermal Cycling | Pass Test: ECSS-Q-70-04 |
| Temperature Range(space) | 65°C to +200°C. Test: Long Term |
| Outgassing Status | Pass |
| Outgassing(Avg data) | TML = 0.30%, RML =0.28%, CVCM = 0.03% Test:ECSS-Q-70-02 |
| Oxygen Index | 49.5 Test: ECSS-Q-70-21 |
| Ionising Radiation | 200Mrad (Co60 source) Data Quality: Manufacturer's data |
| SPECIAL RECOMMENDATIONS |
|---|
| Special Recommendations | Recommended cure: 7 days at room temperature. · DC 93500 can be filled with silica for thixotropy and with silver powder for electrical conductance. In these cases, a high temperature cure is necessary (24 hours @ 80°C). · Where high adhesion is required, use a primer: DC 1200 (red) or DC 92023 (clear). · Sensitive to contamination, particularly when cured in thin layers. · Three commercial versions are available: DC 93500 (thixotropic), DC 93500 (high viscosity) and DC 93500 (low viscosity). |
| Lessons Learned | Lot reproducibility is excellent |