| All data is for information only------(Home) | |
|---|---|
| PRODUCT DATA of AA3003-H24 |
| Material | AA3003-H24 |
| General Information | Strain hardened, partially annealed, 1/2 hard |
| Chemical Composition | 0.8-1.5Mn, 0.7Fe |
| EXPERIENCE IN PRACTICE |
|---|
| Development Status | Commercial Product |
| Cost Range | Low |
| Lot Reproducibility | Good |
| Equivalent Designations | AlMn1, N3, A-M1, 3.0517, Al Mn1Cu, D3S, AA 3003 |
| Space Experience | Good |
| PHYSICAL PROPERTIES |
|---|
| Crystal Structure | Face centered cubic (fcc) |
| Specific Gravity | 2.72 |
| Magnetic Properties | Nonmagnetic |
| ELASTIC PROPERTIES |
|---|
| Tensile Modulus | 69.5 GPa |
| Shear Modulus | 26.1 GPa |
| MECHANICAL PROPERTIES |
|---|
| Ultimate Tensile Strength | 145 MPa(minimum) |
| Proof Stress (0.2%) | 125 MPa(minimum) |
| Elongation | 5 to 9 % |
| Hardness | 45 |
| ELECTRICAL PROPERTIES |
|---|
| Electrical Volume Resistivity | 4.1e-8 ohm.m |
| Electrical Conductivity | 42 %IACS |
| THERMAL PROPERTIES |
|---|
| Thermal Conductivity | 190 W/m.K |
| Thermal Expansion Coefficient | 23.1 µstrain/°C |
| Specific Heat | 0.892 J/g.K |
| Melting Range | 640 to 655 °C |
| RELEVANT PROPERTIES FOR USE IN SPACE COMMUNITY |
|---|
| General Corrosion Status | No specific corrosion protection required |
| Stress Corrosion Status | High Resistance to SCC: Table 1 Data Quality: Design Data |
| Bimetallic Corrosion | Can be used in a non-controlled environment: Al alloys, Cd
Can be used in a clean room environment: Mg, Sn-Pb alloys (all), Sn, Pb, Zn, Be Needs specific measures: All others Data Quality: Design Data |